How to maintain ultrasonic cleaning equipment? When we use ultrasonic cleaning equipment, if it is not well maintained, various problems are likely to occur, which will bring a lot of inconvenience to your cleaning effect. In severe cases, it may shorten the service life of the ultrasonic cleaning machine. We have learned that ultrasonic cleaning equipment is generally composed of an ultrasonic generator and an ultrasonic transducer. The ultrasonic transducer is a sandwich type transducer made of piezoelectric ceramic material. Under the action of an alternating electric field, the piezoelectric ceramic material will generate mechanical vibration. Therefore, the efficient cleaning achieved by ultrasonic cleaning mainly relies on the operation of the ultrasonic generator and ultrasonic transducer. Therefore, when using an ultrasonic cleaner for cleaning, we should pay attention to the following common problems with ultrasonic transducers: (1). If the ultrasonic oscillator gets damp, a megohmmeter can be used to check the plug connected to the transducer. By checking the insulation resistance value, the basic situation can be determined. Generally, the insulation resistance should be greater than 5 megohms. If the insulation resistance value cannot be reached, it is generally because the transducer is damp. The entire transducer (excluding the powder-coated shell) can be placed in an oven set at around 100℃ for drying for 3 hours, or a hair dryer can be used to remove the moisture until the resistance value returns to normal. (2). If the transducer oscillator sparks and the ceramic material breaks, it can be inspected by combining the naked eye and a megohmmeter. Generally, as an emergency measure, individual damaged oscillators can be disconnected without affecting the normal operation of other oscillators. (3). The oscillator has come off the adhesive. Our transducer adopts a dual guarantee process of bonding and screw fastening. Under normal circumstances, this situation will not occur. (4). Perforation of the stainless steel vibrating surface: Generally, after the transducer has been in full-load operation for 10 years, perforation of the vibrating surface may occur.

above by ultrasonic cleaning equipment manufacturer Kejiemeng How to maintain ultrasonic cleaning equipment? ” Since explanations have been provided, we should pay attention to the above-mentioned common problems of ultrasonic cleaning equipment. Only in this way can the ultrasonic cleaning equipment help you complete efficient cleaning for a longer time.