Let's first talk about what the ultrasonic cleaning machine is composed of. It is mainly composed of ultrasonic generators and ultrasonic cleaning tanks. The high-frequency and high-voltage generated by the ultrasonic generator is connected through a cable to form a line and transmitted to the ultrasonic transducer. Then, together with the vibration plate, it generates high-frequency resonance, causing the solvent in the cleaning tank to be affected by ultrasonic waves and clean the dirt. Next, let's talk about what the ten key elements of an ultrasonic cleaner are: 1. Refer to the installation manual of the ultrasonic cleaning machine, connect the electrical control cabinet of the cleaning machine, the signal line of the temperature control ultrasonic sensor between the main units, the ultrasonic drive line and the heater control line, etc. Then connect the 380VAC power supply and install the water supply pipe, drain pipe and overflow discharge pipe of the cleaning machine. 2. Turn on the electric heating switch and point the white scale line on the water temperature adjustment knob to the appropriate temperature. The suitable temperature is 60 degrees Celsius, and the maximum should not exceed 70 degrees Celsius. 3. Add an appropriate amount of clean water to the cleaning tank. The water level should be such that the parts to be cleaned are fully submerged, and it is best not to exceed three quarters of the tank. 4. Before cleaning, use a bamboo knife to briefly clean the dirt off the surface of the components to extend the service life of the cleaning solution. 5. When placing components in the steel bar basket, they should be gently put into the cleaning pool. Try not to put too many parts in at one time. They should be evenly distributed and not overlap. 6. When the ultrasonic cleaner is working normally, ultrasonic waves are emitted simultaneously in three directions. There is too much floating oil on the liquid surface of the cleaning tank. The overflow device of the cleaning machine discharges it to prevent secondary contamination of the workpiece being cleaned. 7. If the movement is to be stopped during the cleaning process, adjust the power knob to the minimum and press the stop button for the ultrasonic operation. 8. Take out the cleaned parts and thoroughly blow off the residual cleaning solution with compressed air. It is best to set up a water pool near the cleaning machine for rinsing the parts. 9. If the cleaning machine washes too many parts, the content of oil sludge in the cleaning agent will be very high. At this time, the cleaning agent will become sticky and weaken its cavitation ability. It is recommended that users configure a water storage tank to be used in conjunction with a cleaning machine for recycling to reduce costs. 10. There are many components that can be easily cleaned thoroughly, while some are not. In such cases, a better cleaning effect can be achieved by soaking and softening the workpiece. < br / > ultrasonic cleaning machine: < a href = "http://www.kejeme.com" > www.gzkjm.com < / a > < br / > & have spent